Product code: 505
Change primer
Styrene–acrylic water-based matt transition primer promoting adhesion of water- or solvent-borne topcoats over aged solvent or water-based films; high-opacity isolation on heavily soiled or dark-to-light transitions reducing topcoat consumption. For render, concrete, thin plaster, brick, etc.
- - Water-based
- - Excellent adhesion
- - Transition from solvent to water systems
- - Sound sealed surface
- - High opacity
- - For demanding adhesion requirements
- Pack sizes: 20 - 10 - 3,5 - 1 Kg
- Colours: White
- Density: 1,45 ± 0,05 gr/ml
- Gloss: Matt
- Solids content: % 70 % ± 5 gr/cm³
- Mould resistance: K-2 general purpose
- Transport and storage: In original packaging with the lid fully closed, protected from sunlight and frost (+5 to 35 °C) can be stored for at least 2 years. Large packs: stack at most 5 units; small packs stack at most 8 units when stacking.
- Safety warnings: S2 Keep out of reach of children S24 Avoid skin contact S25 Avoid eye contact S46 If swallowed seek medical advice immediately Chemical properties:
Remove dust, dirt and blistered coatings; fill and sand defects; substrate dry and clean. Thin Tek Change primer ~10–15% with water; mix well; ≥4 h between coats—two coats recommended.
Never apply over wet, damp or blistered substrates. Brush or roller. Application +5–30 °C. Drying at 20 °C / 60% RH: touch-dry ~1 h, through-dry ~24 h. Coverage ~10–12 m²/L — verify by sample.
No questions have been added for this product yet.
Need Help Choosing a Product?
Contact us to find the best product for your surface type and application needs.